The TOP trailing edge allows up to 100 % higher feed rates than with conventional ISO inserts.
-
Die VPGT 1003… F offers a sharp cutting edge for medium machining, finishing as well as fine finishing.
-
Die VPET 1003… F offers not only a sharp cutting edge but also a narrower tolerance in the plate height. This is an advantage when changing plates without readjusting the centre height.
-
Die VPXT 1003… E is a direct pressed insert with rounded cutting edge for roughing and medium machining.
Advantages:
-
Longitudinal, face and reverse turning with one insert
-
Carbide grades and coatings for steel, INOX and superalloys
-
Corner radii from 0 to 0.35 mm as standard
-
Highly hardened and tempered holders and boring bars
-
Reinforced holder "V" for large chip depths during longitudinal turning